REAR TUG STEP WITHOUT D-RINGS - SPRINTER (2019+) by VAN COMPASS

The rear entry height on the new Mercedes Sprinter VS30 allows for easy loading of cargo, however stepping in or out of the van through the rear doors is quite the leap. That's where the Van Compass Tug Step for the 2019+ VS30 Sprinter comes in. This step is a full width step that bolts onto the vehicle using the factory rear hitch as an attachment point without impeding the functionality of the receiver hitch. The step is high clearance and features no loss of ground clearance or departure angle all while providing an extra level of protection from inconsiderate drivers who like to get too close to our vans when parking in tight spots. The main chassis tie in plates of the rear step are constructed from 3/8" thick high strength steel and feature anchor points for 3/4" D-ring shackles which can be used for recovery pull points.

• Compatible with rear parking sensors.
• Gasoline engine models may require some trimming on the tail pipe for clearance.

The step is 8 5/8" from the back of factory hitch cross tube and 67" wide.

This step protrudes approximately 5" from the face of the plastic bumper cover.