7219 | VanCompass 2 inch Striker Complete Lift Kit (2023 Sprinter 2500 AWD SRW)

The Van Compass Striker AWD lift kit creates the clearance needed to fit larger tires and push deeper into back country landscapes with confidence in the increased capability. Through hours of careful development and design, we've created a system that lifts the van with as few compromises to the original design parameters of the vehicle as possible. Using a mix of machined and welded spacers, we move the front subframe to allow for the CVs, tie rods, and control arms to all cycle in their original geometry range set by Mercedes. At the rear, a taller version of our Mini Leaf Spring pack is paired with longer sway bar links, shock relocation brackets, and bump stop spacers to ensure that nothing binds, over-extends, or can over-compression on axle articulation. With proper wheel offset and fender trimming, fitment of a 35 x 12.50 tire is possible, for a huge increase in traction and ground clearance.

Included Components
Front 2" strut spacers
Front 2" subframe drop spacers
Engine and transmission mount 2" lift spacers
Front differential re-clocking cams
CNC Machined 2" steering shaft extension
Low pressure power steering hose extension
Front brake line relocation brackets
6-leaf Mini Leaf Spring pack
Extended rear sway bar links
Rear lower shock relocation brackets
Rear bump stop drop brackets
Wind assist or headlight leveling sensor bracket
All necessary hardware and detailed instructions

With this lift kit, 35 x 12.50 (315/70R17 equivalent) tires can be fitted with the following conditions met:

Removal of the front mudflaps.
Slight trimming to the rear of the front fender opening.
Trimming of the front bumper and front inner fender well liner.
Minimum 14mm wheel spacer (9/16") if retaining factory 54mm offset steel wheels.
This is for tire clearance between the inside of the tire and the strut and rear inner fender.
Aftermarket wheels with an additional 14mm offset.

Installation Time: 12 Hours