7219-OPTI | VanCompass 2 inch Opti-Rate Striker Complete Lift Kit (2023 Sprinter 2500 AWD SRW)

The Van Compass Striker AWD lift kit creates the clearance needed to fit larger tires and push deeper into back country landscapes with confidence in the increased capability. Through years of careful development and design, we've created a system that lifts the van with as few compromises to the original design parameters of the vehicle as possible. This kit is designed specifically for the Sprinter AWD platform.

Using a mix of machined and welded spacers, we space the front subframe down to allow for the CVs, tie rods, and control arms to all cycle in their original geometry range set by Mercedes. At the rear, our Opti-Rate rear leaf spring pack is paired with a 2" lift block, longer sway bar links, shock relocation brackets, and bump stop spacers to ensure that nothing binds, over-extends, or can over-compress on axle articulation.

The innovative design of our Opti-Rate springs allows the end-user to fine tune their spring rate and ride height easily, and is best suited for vans heavy vans in the 9-10,000 lb range and higher, like upgraded Storytellers and Revels, 170 EXT vans with heavy interior build outs, or vans that will carry extra weight behind the rear axle on door carriers, hitch racks and trailers. With proper wheel offset and fender trimming, fitment of a 35 x 12.50 tire is possible, for a huge increase in traction and ground clearance.

Included Components
Front 2" strut spacers
Front 2" subframe drop spacers
Engine and transmission mount 2" lift spacers
Front differential cam bolt kit
CNC Machined 2" steering shaft extension
Low pressure power steering hose extension
Front brake line relocation brackets
Opti-Rate Rear leaf spring pack
2" rear lift block
Extended rear sway bar links
Rear lower shock relocation brackets
Rear bump stop drop brackets
Wind assist or headlight leveling sensor bracket
All necessary hardware and detailed instructions

With this lift kit, 35 x 12.50 (315/70R17 equivalent) tires can be fitted with the following conditions met:

Removal of the front mudflaps.
Slight trimming to the rear of the front fender opening.
Trimming of the front bumper and front inner fender well liner.
Minimum 14mm wheel spacer (9/16") if retaining factory 54mm offset steel wheels.
This is for tire clearance between the inside of the tire and the strut and rear inner fender.
Aftermarket wheels with an additional 14mm offset.

Installation Time: 12 Hours