49-46029-P | AFE Power MACH Force-Xp 2-1/2 IN to 3 IN 409 Stainless Steel Cat-Back Exhaust w/Polish Tip (2007-2018 FJ Cruiser V6-4.0L)

MACH Force-Xp 3" to 2-1/2" Stainless Steel Cat-Back Exhaust System

Test Results:

In testing, the cat-back exhaust system resulted in gains up to +6 horsepower and +11 lbs. x ft. of torque, as measured on our in-house dyno (tested on 2008 Toyota FJ Cruiser V6-4.0L)

aFe POWER introduces the MACH Force-Xp cat-back dual exhaust system for the 2007-2017 Toyota FJ Cruiser with V6-4.0L engine. This dual exhaust system is constructed out of 3" to 2-1/2" 100% MIG-welded, mandrel-bent, stainless steel tubing for maximum flow. The smooth transition bends allow for low turbulence, increasing horsepower, torque and improved throttle response. A free-flow single-in dual out muffler is included which improves performance across the power band while maintaining an awesome sound. Finishing off this exhaust are dual 4-1/2" diameter polished tips. The tips come with a laser-cut aFe POWER badge riveted on for an aggressive style.

Installation is a Snap:

This system uses factory mounting locations and includes a bolt on hanger mount to support the driver side tube. This makes for an easy installation with no cutting required.

Leak-Free Seal:

An OE style flange and high quality band clamps are used for a complete 360-degree sealing surface eliminating leak paths.

Aggressive Sound:

A single in dual out, free-flowing stainless steel muffler is used to absorb high pitch tones producing a powerful sound and unleashing all available horsepower and torque.

Perfect Fit:

OE-style bayonet hangers are used to maintain a stable pipe location during high vibration and high heat conditions. The bayonet tip holds the hanger bushing in place for an OE-style fit that does not change with time.

Dual 4-1/2" Dia. Polished Tips:

Finishing off this system are dual 4-1/2" diameter, polished, stainless steel tips. The tips come with a laser-cut aFe Power badge riveted on for an aggressive style.

Note: Removal of the skid plate required for TRD models

Emissions Disclaimer:
This product does not require a CARB EO#

All aFe exhaust systems are engineered and manufactured in our Corona, California facility.